Symbol Technologies ES3000 manual Supplying Power, Terminal Type VT-100 Communication, Mode

Switch Management Overview 1-5

1.5.3 Supplying Power

To cable the ES3000 Ethernet Switch to receive power:

1.Connect the supplied AC power cord to the power connector on the rear of the Ethernet Switch.

2.Plug the cord into a standard AC outlet with a voltage range from 100VAC to 240VAC. The Ethernet Switch is ready to receive power.

1.5.4Establishing a RS-232 Serial Connection to the Ethernet Switch

The initial configuration of the Ethernet Switch is set using the serial port. To establish the RS-232 serial connection:

1.Connect the port to a RS-232 (DB-9) serial port on the configuring computer using the supplied cable.

2.Use a terminal emulation application to access the command line interface (CLI) through the console port.

3.Configure the terminal emulation application and operating system to support the following serial port specifications:

Terminal Type	VT-100
Communication	8	- data bits
Mode	1	- stop bit

no parity

19200 bps transfer rate no flow control

no hardware compression