Symbol Technologies ES3000 manual Show snmp command has no default setting

Command Line Interface 5-21

show snmp

Use the show snmp command to display snmp trap-receivers information.

show snmp

SYNTAX DESCRIPTION:			The show snmp command has no arguments or keywords.
DEFAULT VALUE:			The show snmp command has no default setting.
COMMAND MODES:			Privileged EXEC
REFERENCE:			Cisco
MENU:			Basic Switch Configuration -> SNMP Configuration Menu
EXAMPLE:
Switch# show snmp				IP Address			Community
No.		Status	Previlige
----		--------	-----------	--------------			--------------------
1		Enabled	Read-Write	0.0.0.0			NETMAN
2		Enabled	Read-Only	0.0.0.0			PUBLIC
3		Disabled	Read-Only	2.2.2.2			123416
5		Disabled	Read-Write	1.1.1.1			123
Trap-Receiver			IP Address	Community
No.		Status
----		--------	-------------- ----------------------------
3		Enabled	172.16.3.77	PUBLIC
Individual Trap				Disabled
Authentication Failure:
Enable Link Up/Down Port:				1 - 12
OSPF Trap Control:					2.	Neighbor_State_Change : Down
1.	Virtual_IF_State_Change : Down
3.	Virt_Nei_State_Change			: Down	4.	IF_Config_Err		: Down
5.	Virt_IF_Config_Err			: Down	6.	IF_Auth_Failure		: Down
7.	Virt_IF_Auth_Failure			: Down	8.	IF_RX_Bad_Packet		: Down
9.	Virt_IF_RX_Bad_Packet			: Down	10.	IF_TX_Retransmit		: Down
11.	Virt_IF_TX_Retransmit			: Down	12.	Originate_LSA		: Down
13.	MAX_AGE_LSA			: Down	14.	LSDB_Overflow		: Down
15.	LSDB_Approach_Overflow			: Down	16.	IF_State_Change		: Down

Basic System Management Commands

Switch#