Command Descriptions
2–86 TLS 216 Programmer Manual
 
 
 ranges from 1 to the record length and is the first data point the instrument
transfers. Data will be transferred from  to DATa:STOP or the record
length, whichever is less. If  is greater than the record length then no data
will be transferred. When DATa:STOP is less than DATa:STARt, the values will
be swapped internally for the CURVe? query.
 
specifies that the waveform transfer will begin with data point 10.

might return  as the first waveform data point that will be transferred.
DATa:STOP
Sets or queries the last data point to be transferred when using the CURVe?
query. This allows the transfer of partial waveforms to the controller.
When using the CURVe command, the logic scope stops reading data when there
is no more data to read or the specified record length has been reached (the
command will be ignored).
Waveform
CURVe?, DATa SNAp
 

 
 
 ranges from 1 to the record length, and is the last data point the instru-
ment transfers. If  is greater than the record length then the instrument will
transfer data up to the record length. If both DATa:STARt and DATa:STOP are
greater than the record length, an execution error will be returned. When
DATa:STOP is less than DATa:STARt the values will be swapped internally for
the CURVe? query.
Arguments
Examples
Group
Related Commands
Syntax
Arguments