Command Descriptions
2–184 TLS 216 Programmer Manual
MEASUREMENT:MEAS4:STATE?
returns either 0 or 1, indicating the state of MEAS4.
MEASUrement:MEAS<x>:TYPe
Sets or queries the measurement type for MEAS<x>. MEAS<x> is one of the
four measurements available (named Measurement 1 through Measurement 4)
where <x> specifies 1 through 4. Using this command is equivalent to selecting
the measurement in the Select Measurement side menu.
Measurement
MEASUrement:MEAS<x>:TYPe { AMPlitude | AREA | BURst | CARea |
CMEan | CRMs | DELay | FALL | FREQuency | HIGH | HOLDTime | LOW |
MAXimum | MEAN | MINImum | NDUty | NOVershoot | NWIdth | PDUTy |
PERIod | PHAse | PK2pk | POVershoot | PWIdth | RISe | RMS | SETUp
| SKEw }
MEASUrement:MEAS<x>:TYPe?
Group
Syntax