Toshiba B-570 manual L I N E, Press the Pause key. See Note, U S E

6. DIAG. TEST OPERATION

EM18-33010A (Revision Date Sep. 27, ’95)

6.1 OUTLINE OF THE DIAG. TEST OPERATION

■Type II

The parameter setting such as feed length fine adjustment or cut/strip position fine adjustment can be changed while the printer is on-line or printing. Pressing the [PAUSE] key causes the printer to enter parameter setting mode. Reset mode is provided for this procedure to cancel the steps which follow the [PAUSE] key without turning the power off.

Power on

O N L I N E

Press the [PAUSE] key. (See NOTE 1.)

P A U S E 5

Press the [PAUSE] key. Hold down the [RESTART] key for more than 3 seconds. (See NOTE 2.)

< 1 > R E S E T

(See NOTE 3.)

Press the [RESTART] key.

Indicates the number of remaining media when the [PAUSE] key is pressed.

< 2 > P A R A M E T E R S E T

Press the [FEED] key and [RESTART] key at the same time.

Press the [PAUSE] key.

Refer to Section 6.3 Parameter Setting Mode for the following procedure.

Press the [RESTART] key.

NOTES: 1. Pressing the [PAUSE] key during printing causes the printer to pause printing and show the number of remaining media.

2.If the [RESTART] key is released within 3 seconds, the printer will resume printing because the [RESTART] key is activated.

3.Since the reset is performed when terminating this mode, the printer cancels the remaining media and returns to on-line mode. This reset will not clear the changed parameter settings.

6-2