Toshiba B-570 manual Process Test Print, ∙ Print Tone Fine Adjustment Value +

6. DIAG. TEST OPERATION

EM18-33010A (Revision Date Jan. 13, ’95)

6.4 TEST PRINT MODE

6.4.2Process Test Print

In the process test print, the test print is automatically performed on the following conditions. Parameter setting and print tone fine adjustment value is ignored.

∙ OPERATION : One label feed, 3-dot slant line print, bar code print, character print

∙ISSUE COUNT : 5 labels each

∙PRINT SPEED : 8 inches/sec.

∙ SENSOR	: Transmissive sensor (feed gap sensor) or reflective sensor (black mark
∙ RIBBON	sensor)
	: Transmissive ribbon
∙ TYPE	: Batch (without cut)

∙LABEL LENGTH: 76 mm

∙PRINT TONE FINE ADJUSTMENT VALUE : + 0

Operating procedure for the test mode is provided below.

		Power off
		Turn on the power while
		holding down the [FEED]
		key and [PAUSE] key.
	< 1 > D I A G N O S T I C		V 1 . O A
	Press the [FEED] key twice.
From C on
the next page.
	< 3 > T E S T P R I N T
		Press the [PAUSE] key.

Press the [RESTSRT] key.

To A of the

preceding page.

P R I N T C O N D I T I O N

Press the [RESTART] key.

After feeding one label, slant lines (3 dots) are printed on 5 labels.

A U T O P R I N T ( R E F L E C T . )

Press the [PAUSE] key.	Press the [FEED] key
	and [RESTART] key
[Bar codes are printed on 5 labels.]
	at the same time.
To be continued on
	To C of the
B of the next page.	preceding page.

6-46