6. DIAG. TEST OPERATION
6.3 PARAMETER SETTING MODE
■Strip Position Fine Adjustment Example
+ 0.0 mm
+ 3.0 mm
+ 3.0 mm
-3.0 mm
-3.0 mm
Label | Print Head |
|
|
| |
| Platen | Fig. |
Backing Paper | Strip Shaft |
|
| Print Head |
|
| Platen | Fig. |
|
| |
Backing Paper | Strip Shaft |
|
| Print Head |
|
| Platen | Fig. |
Backing Paper | Strip Shaft |
|
NOTE: The print stop position when printing the label in strip mode varies according to label length as the strip mode printing stops so that the edge of the strip shaft is 4 mm from the middle of the gap. This is because the gap length is programmed as 2mm. When the gap length is 5 mm or more, the effective print length should be set to the value obtained by subtracting 2 mm from the label pitch, that is, set the gap length to 2 mm. If the print format hangs over the gap as a result, correct the print start position. If the print stop position is improper, refer to Section 6.3.2 and make a fine adjustment.
4 mm
3 mm
Label |
|
|
|
| 2 mm | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Platen
Strip Shaft | Backing Paper | Fig. |
