Toshiba B-570 2 Cut/Strip Position Fine Adjustment, Press the Pause key twice, T a D J U S T

6. DIAG. TEST OPERATION

EM18-33010A (Revision Date Jan. 13, ’95)

6.3 PARAMETER SETTING MODE

6.3.2Cut/Strip Position Fine Adjustment

Power off

Turn on the power while holding down the [FEED] key and [PAUSE] key.

< 1 > D I A G N O S T I C V 1 . 0 A

Press the [FEED] key.

< 2 > P A R A M E T E R S E T

Press the [PAUSE] key twice.

C U T A D J U S T + 0 . 0 m m

Press the [FEED] or [RESTART] key to adjust the feed length.

(See NOTE 1.)

■ [FEED] key:	Pressing the [FEED] key one time
	is a -0.5 mm change, up to -50.0

mm. (See NOTE 2.)

■[RESTART] key: Pressing the [RESTART] key one time is a +0.5 mm change, up to +50.0 mm. (See NOTE 2.)

Press the [FEED] key and [RESTART] key at the same time.

Press the [PAUSE] key.

Continued on Section 6.3.3 Back feed length fine adjutment.

NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast forward.

2.Max. fine adjustment ±50.0 mm = Key fine adjustment value (±50.0 mm) + PC fine adjustment value ( ± 50.0 mm)

When the value reaches the maximum, the value remains unchanged even if a subsequent fine adjustment is performed.

3.A changed cut/strip position value is stored in memory by pressing the [PAUSE] key.

4.When using label with length of less than 38 mm, calculate the cut position fine adjustment value using the expression provided on page 6-19.

6-16