STE 58760

(Parity)

Specifies whether to check the parity of each character to be communicated.

Absence of parity check

... 0

Odd parity

... 1

Even parity

... 2

(Stop bit length)

Specifies the stop bit length of each character to be communicated. 1 bit ... 1

2 bits ... 2

Data should be separated by commas and specified in sequence. The data of each channel should be specified on four lines in sequence.

Example)

Assume that communication channel 1 is to be used for a printer and communication channel 2 is to be used for the host computer.

[="PRT"

0 0 1200 8 0

1

="HOST"

0 1 2400 7 1

2

="COM3"

0 0 2400 8 1

2

="COM2"

0 0 4800 7 2

2]

In this example, communication channel 1 is set to "printer, no procedure, 1200 bps, 8 bit characters, no parity check, and 1 stop bit". Communication channel 2 is set to "host computer, simple procedure (presence of check sum), 2400 bps, 7 bit characters, odd parity, 2 stop bits". Communication channel 3 is not set to any port with no procedure, 2400 bps, 8 bit characters, odd parity, 2 stop bits". Communication channel 2 is not set to any port with 4800 bps, 7 bit characters, even parity, 2 stop bits".

Note 1)

Set all the four channels for the communication mode. (As channel 4 is unused, however, it should be set as the dummy.)

Note 2)

The communication channel 0 (COM0) is a channel dedicated for the teach pendant. The parameters for this channel cannot be changed.

3-23

Page 82
Image 82
Toshiba STE 58760 instruction manual =Host