Unisys EFP9800 manual Switch Entry Mode

Diagnostics and Print Tests

Switch Entry Mode

Use Switch Entry mode to set the printer emulation or the internal switch pack values in NVRAM.

Note: For an alternate method to set the emulation and switch settings, see “Section 10: Flash Download Commands.”

The EFP9800 printer can emulate the following printers and emulations:

•Epson ESC/POS (370/5) printer

Note: This emulation is included in the EFP9800 ESC/POS commands.

•Ithaca Peripherals Proprinter emulation

•NCR 5021 printer (EFP984x Serial Interface Units Only)

•EF4270 printer

Note: The EFP9800 FLASHADMIN software utility can also be used for emulation and internal DIP switch configuration. This utility is included in the EPF9800-SW1 style package.

The EFP9800 printer has one set of DIP switches, while some of the emulated printers have two or more sets. You can enter values for the extra switch packs into “internal switch packs” stored in NVRAM.

Note: Secure the roller assembly in a closed position to eliminate the nuisance noise from occurring when the take-up assembly is not being used.

All procedures completed in Switch Entry mode include two steps:

•First, tell the printer what you want to do—either choose an emulation or choose an internal switch pack value. (For example, choose the Ithaca Peripherals Proprinter emulation or internal switch pack 2.)

•Second, enter the value for the operation—either the specific printer emulation or the values for the internal switch pack.

Both steps are completed by setting the DIP switches. During the first step, the Slip In LED is on. During the second step, the Slip In LED is off.

Once you’ve finished setting options in Switch Entry mode, turn off the printer and set the DIP switches back to the settings for the appropriate communication protocol. The options you set in Switch Entry mode are stored in “internal switch packs” in NVRAM until you change them.

3–4 3255 4073–002