Unisys manual EFP9800 ESC/POS Commands

EFP9800 ESC/POS Commands

Notes for Bit 1:

•The slip paper status becomes 0 (Printable) after paper is loaded and becomes 1 (Not Printable) when the paper is ejected or the printer times out.

•When the slip paper is selected and the printer goes into the slip waiting state, bits 5 and 6 of the third byte become 1 (No Paper) and bits 0 and 1 of the fourth byte become 0 (Slip Selected) and 1 (Not Printable) respectively.

•When the paper sensor for slip paper is disabled using the Select Paper Sensor(s) to Stop Printing command (1B 63 34), the slip status does not become 1 (Not Printable) even when there is no printable area. To avoid this, confirm the printable area using the Transmit Status command (1D 72).

Notes for Bit 3:

•The validation paper state becomes 0 (Printable) after paper is loaded and becomes 1 (Not Printable) when the paper is ejected or the printer times out.

•When the validation paper is selected and the printer goes into the validation waiting state, bits 5 and 6 of the third byte become 1 (No Paper) and bits 2 and 3 of the fourth byte become 0 (Validation Selected) and 1 (Not Printable) respectively.

•When the paper sensor for validation paper is disabled using the Select Paper Sensor(s) to Stop Printing command (1B 63 34), the validation status does not become 1 (Not Printable) even when there is no printable area. To avoid this, confirm the printable area using the Transmit Status command (1D 72).

The default values for n are:

•when DIP switch 2-3 are Off.

•when DIP switch 2-3 are On.

6– 52 3255 4073– 002