Unisys EFP9800 manual Diagnostic Print Tests, Print Configuration Information

Diagnostics and Print Tests

Diagnostic Print Tests

Three diagnostic print tests and a general print test are available:

•Print configuration, ROM CRC, and internal switch packs information.

•Continuous slip printing.

•Print each character in the ASCII character set.

•General print test

The following procedures describe how to run each of these tests.

Print Configuration Information

This test produces a printout of all ROM CRC, internal switch pack, and configuration information. See the sample printout later in this section.

1.Turn the printer off.

2.Turn the printer to the back to access the DIP switches and write down the current switch settings.

3.Set the DIP switches to the following settings:

Switch	Switch	Switch	Switch	Switch	Switch	Switch	Switch
1	2	3	4	5	6	7	8
ON	OFF	N/A	ON	ON	ON	N/A	N/A

4.Turn the printer back on to begin printing the test.

5.Turn the printer off to stop the test.

6.Turn the printer off and reset the DIP switches to what they were when you started.

For normal operation settings, see “Setting Switches” in section 5.

7.Turn the printer back on to begin normal operation.

3–28 3255 4073–002