Unisys EFP9800 manual Select Papers For Setting Line Spacing

EFP9800 ESC/POS Commands

Notes:

•When the paper selection changes, if slip or validation was previously selected, the slip or validation paper is ejected.

•When either slip or validation is selected, the printer waits for the paper to be inserted.

•When both slip and receipt/journal paper are selected at once, printing on the pressure roll is possible only when pressure-sensitive paper is used.

•If the previously selected paper is re-selected, no action takes place.

Select Paper(s) For Setting Line Spacing

Selects paper for use with the following commands:

•Select Default Line Spacing (1B 32)

•Set Line Spacing (1B 33)

•Set Slip Eject Length (1B 43)

The command is ignored if n is out of range. The default is n = 15.

Hexadecimal		Decimal	ASCII
1B 63 31 n		27 99 49 n	ESC c 1 n
				Paper Type Status
Bit	Paper Type		0		1
0	Receipt/Journal Paper			Not Selected	Selected
1	Receipt/Journal Paper			Not Selected	Selected
2	Slip			Not Selected	Selected
3	Validation			Not Selected	Selected

4-7 Undefined

Note: If a different line spacing is set for the receipt/journal paper and slip, and both are selected for printing, then using the Paper Feed button to print and feed paper causes the line spacing to be set for the slip.

3255 4073– 002 6– 23