Unisys EFP9800 manual Validating Slips and Checks

Operating the Printer

Validating Slips and Checks

The EFP9800 can print on slips and forms up to five-parts thick (the receipt is included as one or two of the parts depending if it is one-ply or two-ply). For more information on the types of slips and forms you can use, see “Ordering Paper and Supplies” in section 1.

Follow this procedure to validate slips and checks.

Note: Do not use this procedure for check verification. See “Verifying Checks” earlier in this section.

Be sure to insert the slip or check properly to ensure printing in the correct locations. Insert standard size slips and checks from the top, using the slip stop to position them correctly.

1.Insert the slip/check from the top, with the side to be printed facing you as shown in the illustration.

2.Slide the slip/check into the printer until it meets the slip stop and to the right until it lines up against the wall.

The Slip In LED flashes green. When the slip/check is inserted properly, the Slip In LED is lit steadily.

3.Depending on your printer setup, the printer may automatically begin printing, or you may have to perform the action programmed for your printer, such as pressing a particular keyboard key. Follow the instructions from the host computer.

2–12 3255 4073–002