Unisys EFP9800 manual Choose a Printer Emulation

Diagnostics and Print Tests

Use the diagnostics print tests to print the name of the emulation which is currently active and the settings of the NVRAM switch packs. See “Diagnostics Print Tests” later in this section for information about running the tests.

Choose a Printer Emulation

Caution

The DIP switches are set at the factory to predetermined settings. Change the settings carefully to avoid changing other functions. Run the Diagnostic Print Tests to see what emulation the printer is set for. For more information, see “Diagnostic Print Tests” later in this section.

1.Turn the printer off.

2.Turn the printer to the back to access the DIP switches and write down the current switch settings.

3.To put the printer into Switch Entry mode, set the DIP switches to the following settings:

Switch	Switch	Switch	Switch	Switch	Switch	Switch	Switch
1	2	3	4	5	6	7	8
ON	ON	OFF	OFF	OFF	OFF	OFF	OFF

4.Turn the printer back on.

The printer is now in Switch Entry Mode as indicated by the green Online LED and the red Paper Status LED flashing. The green Slip In LED may be on or off, depending on your input at the time.

5.To indicate to the printer that you are choosing a printer emulation, set all of the DIP switches to Off.

6.Press the Paper Feed button. The green Slip In LED turns off.

3255 4073–002 3–5