If your tablet battery has exceeded its life span and can no longer be charged or no longer holds a charge, it will need to be replaced. Be sure to use only the rechargeable battery designed for your tablet. For information, see ordering parts and accessories.
Important: Only use a Wacom battery specified for your tablet.
To replace the rechargeable battery:
1.Turn the tablet over. Remove the wireless compartment cover. Medium- and
2.Carefully remove the old battery as shown below.
3.Install the new battery. Align the terminals of the new battery with the tablet contacts as shown below. Press the battery into the compartment.
4.Replace the wireless compartment cover. Align and slide into place.
5.Connect the USB cable and charge the battery for optimum performance. See charging the battery.
Remove old battery.
Be sure to first lift battery edge before sliding battery out of the compartment.
Install new battery.
Carefully install the battery at the angle shown to prevent damaging the battery contacts.
Important: When replacing the battery, be careful not to drop it on hard surfaces. The battery can be damaged internally when dropped, and should be replaced even if there is no obvious damage. This will help prevent any future damage that could occur to the tablet if the battery has been dropped, is installed in the tablet, and then later develops a short or leak while in the tablet.
Warning: See the Important Product Information guide for battery safety precautions.
Many communities offer voluntary or mandatory recycling programs for batteries. Properly recycle the old battery by following all applicable laws, and in accordance with the safety precautions for
ContentsIndex
85
