¾Split the documents into sections for individual programming.

¾Select [Build Job] and then [On].

¾Programme the job requirements for the first section of the job.

¾Load only the first section in to the document feeder or place the document on the glass.

¾Select [Start].

Copy

NOTE: If more than a quantity of 1 has been selected, the machine, depending on the features programmed, will copy 1 set of each section. The remaining sets will be copied at the end of the job.

¾When the first section has finished scanning remove the originals.

¾From the [Build Job] screen make selections for the next section of the job and select [Start].

¾Repeat the steps above for each selection of the job.

¾After the last section has been scanned, select [End Build Job] to indicate that the job has been completed. The machine will complete the quantity selected.

Xerox Document Centre 440/432/430/426/425/420 User Guide

Page 3-49

Page 109
Image 109
Xerox 432, 440, 430, 426, 425, 420 manual Copy