ZyWALL 2 Series User’s Guide
Table
LABEL | DESCRIPTION | EXAMPLE |
|
|
|
Drop | Type the AT Command string to drop a call. "~" represents a one | ~~+++~~ath |
| second wait, for example, "~~~+++~~ath" can be used if your modem |
|
| has a slow response time. |
|
|
|
|
Answer | Type the AT Command string to answer a call. | ata |
|
|
|
Drop DTR When | Select this check box to have the ZyWALL drop the DTR (Data |
|
Hang Up | Terminal Ready) signal after the "AT Command String: Drop" is sent |
|
| out. |
|
|
|
|
AT Response Strings |
| |
|
|
|
CLID | Type the keyword that precedes the CLID (Calling Line Identification) | NMBR |
| in the AT response string. This lets the ZyWALL capture the CLID in |
|
| the AT response string that comes from the WAN device. CLID is |
|
| required for CLID authentication. |
|
|
|
|
Called ID | Type the keyword preceding the dialed number. |
|
|
|
|
Speed | Type the keyword preceding the connection speed. | CONNECT |
|
|
|
Call Control |
|
|
|
|
|
Dial Timeout | Type a number of seconds for the ZyWALL to try to set up an | 60 |
(sec) | outgoing call before timing out (stopping). |
|
|
|
|
Retry Count | Type a number of times for the ZyWALL to retry a busy or | 0 |
| phone number before blacklisting the number. |
|
Retry Interval | Type a number of seconds for the ZyWALL to wait before trying | 10 |
(sec) | another call after a call has failed. This applies before a phone |
|
| number is blacklisted. |
|
|
|
|
Drop Timeout | Type the number of seconds for the ZyWALL to wait before dropping | 20 |
(sec) | the DTR signal if it does not receive a positive disconnect |
|
| confirmation. |
|
|
|
|
Call Back Delay | Type a number of seconds for the ZyWALL to wait between dropping | 15 |
(sec) | a callback request call and dialing the corresponding callback call. |
|
|
|
|
Apply | Click Apply to save your changes back to the ZyWALL. |
|
|
|
|
Cancel | Click Cancel to exit this screen without saving. |
|
|
|
|
WAN Screens |