ZyWALL 2 Series User’s Guide

Table 23-1 MAC Address Cloning in WAN Setup

 

FIELD

DESCRIPTION

EXAMPLE

 

 

 

 

 

IP Address

This field is applicable only if you choose the IP address attached on

192.168.1.35

 

 

LAN method in the Assigned By field. Enter the IP address of the

 

 

 

computer on the LAN whose MAC you are cloning.

 

 

 

 

 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your configuration, or press [ESC] at any time to cancel.

23.2 Dial Backup

The Dial Backup port can be used in reserve, as a traditional dial-up connection should the broadband connection to the WAN port fail. To set up the auxiliary port (Dial Backup) for use in the event that the regular WAN connection is dropped, first make sure you have set up the switch and port connection (see the Quick Start Guide), then configure

1.Menu 2 - WAN Setup,

2.Menu 2.1 - Advanced WAN Setup and

3.Menu 11.1 - Remote Node Profile (Backup ISP) as shown next

Refer also to the traffic redirect section for information on an alternate backup WAN connection.

23.3 Configuring Dial Backup in Menu 2

From the main menu, enter 2 to open menu 2.

Menu 2 - WAN Setup

MAC Address:

Assigned By= Factory default

IP Address= N/A

Dial-Backup:

Active= No

Phone Number=

Port Speed= 9600

AT Command String:

Init=

Edit Advanced Setup= No

Press ENTER to Confirm or ESC to Cancel:

Figure 23-2 Menu 2: Dial Backup Setup

23-2

WAN and Dial Backup Setup