ZyWALL 2 Series User’s Guide
Table
FIELD | DESCRIPTION | DEFAULT |
|
|
|
IP Address | Enter the IP address of your ZyWALL in dotted decimal notation. | 192.168.2.1 |
|
|
|
IP Subnet Mask | Your ZyWALL will automatically calculate the subnet mask based | 255.255.255.0 |
| on the IP address that you assign. Unless you are implementing |
|
| subnetting, use the subnet mask computed by the ZyWALL. |
|
|
|
|
RIP Direction | Press [SPACE BAR] and then [ENTER] to select the RIP | None |
| direction. Options are |
|
| Both, In Only, Out Only or None. |
|
Version | Press [SPACE BAR] and then [ENTER] to select the RIP version. | |
| Options are |
|
|
| |
Incoming | Enter the filter set(s) you wish to apply to the incoming traffic | 1 |
Protocol Filters | between this node and the ZyWALL. |
|
|
|
|
Outgoing | Enter the filter set(s) you wish to apply to the outgoing traffic | 2 |
Protocol Filters | between this node and the ZyWALL. |
|
|
|
|
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to save your configuration, or press [ESC] at any time to cancel.
24.5 Wireless LAN Setup
Use menu 3.5 to set up your ZyWALL 2WE as the wireless access point.
See the Web configurator parts for instructions on WEP and configuring the MAC address filter.
If you are configuring the ZyWALL from a computer connected to the wireless LAN and you change the ZyWALL’s ESSID or WEP settings, you will lose your wireless connection when you press [ENTER] to confirm. You must then change the wireless settings of your computer to match the ZyWALL’s new settings.
From the main menu, enter 3 to open Menu 3 – LAN Setup to configure the Wireless LAN setup. To edit the wireless LAN configuration, enter 5 to open Menu 3.5 – Wireless LAN Setup as shown next.
LAN Setup |