ZyWALL 2 User’s Guide

Step 1. Launch the FTP client on your computer.

Step 2. Enter “open”, followed by a space and the IP address of your ZyWALL. Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter your password as requested (the default is “1234”).

Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Find the “rom” file (on your computer) that you want to restore to your ZyWALL.

Step 7. Use “put” to transfer files from the ZyWALL to the computer, for example, “put config.rom rom-0” transfers the configuration file “config.rom” on your computer to the ZyWALL. See earlier in this chapter for more information on filename conventions.

Step 8. Enter “quit” to exit the ftp prompt. The ZyWALL will automatically restart after a successful restore process.

33.4.2 Restore Using FTP Session Example

ftp> put config.rom rom-0 200 Port command okay

150 Opening data connection for STOR rom-0

226 File received OK

221 Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit

Figure 33-8 Restore Using FTP Session Example

Refer to section 33.3.5 to read about configurations that disallow TFTP and FTP over WAN.

33.4.3 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

Firmware and Configuration File Maintenance

33-9