ZyWALL 2 Series User’s Guide

Menu 12.1 - Edit IP Static Route

Route #: 1

Route Name= ?

Active= No

Destination IP Address= ?

IP Subnet Mask= ?

Gateway IP Address= ?

Metric= 2

Private= No

Press ENTER to Confirm or ESC to Cancel:

Figure 27-2 Menu 12. 1: Edit IP Static Route

`The following table describes the IP Static Route Menu fields.

 

Table 27-1 Menu 12. 1: Edit IP Static Route

 

 

FIELD

DESCRIPTION

 

 

Route #

This is the index number of the static route that you chose in menu 12.

 

 

Route Name

Enter a descriptive name for this route. This is for identification purposes only.

 

 

Active

This field allows you to activate/deactivate this static route.

 

 

Destination IP

This parameter specifies the IP network address of the final destination. Routing is

Address

always based on network number. If you need to specify a route to a single host, use

 

a subnet mask of 255.255.255.255 in the subnet mask field to force the network

 

number to be identical to the host ID.

IP Subnet Mask

Enter the IP subnet mask for this destination.

 

 

Gateway IP

Enter the IP address of the gateway. The gateway is an immediate neighbor of your

Address

ZyWALL that will forward the packet to the destination. On the LAN, the gateway must

 

be a router on the same segment as your ZyWALL; over the WAN, the gateway must

 

be the IP address of one of the remote nodes.

 

 

Metric

Enter a number from 1 to 15 to set this route’s priority among the ZyWALL’s routes

 

(see the Metric section in the WAN and Dial Backup Setup chapter). The smaller the

 

number, the higher priority the route has.

 

 

Private

This parameter determines if the ZyWALL will include the route to this remote node in

 

its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP

 

broadcast. If No, the route to this remote node will be propagated to other hosts

 

through RIP broadcasts.

 

 

Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to Confirm…” to save your configuration, or press [ESC] to cancel.

27-2

IP Static Route Setup