ZyWALL 2 Series User’s Guide

 

 

Table 6-6 PPTP Encapsulation

 

 

 

 

 

LABEL

DESCRIPTION

 

 

 

 

 

 

User Name

Type the user name given to you by your ISP.

 

 

 

 

 

 

Password

Type the password associated with the User Name above.

 

 

 

 

 

 

Retype to Confirm

Type your password again to make sure that you have entered is correctly.

 

 

 

 

 

 

Nailed-up

Select Nailed-Up Connection if you do not want the connection to time out.

 

 

Connection

 

 

 

 

 

 

 

Idle Timeout

This value specifies the time in seconds that elapses before the ZyWALL

 

 

 

automatically disconnects from the PPTP server.

 

 

 

 

 

 

PPTP Configuration

 

 

 

 

 

 

 

My IP Address

Type the (static) IP address assigned to you by your ISP.

 

 

 

 

 

 

My IP Subnet Mask

Your ZyWALL will automatically calculate the subnet mask based on the IP

 

 

 

address that you assign. Unless you are implementing subnetting, use the subnet

 

 

 

mask computed by the ZyWALL.

 

 

 

 

 

 

Server IP Address

Type the IP address of the PPTP server.

 

 

 

 

 

 

Connection ID/Name

Type your identification name for the PPTP server.

 

 

 

 

 

 

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

 

 

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

 

 

 

6.6Configuring WAN IP

To change your ZyWALL’s WAN IP settings, click WAN, then the WAN IP tab. This screen varies according to the type of encapsulation you select.

If your ISP did not assign you a fixed IP address, click Get automatically from ISP (Default);otherwise click Use fixed IP Address and enter the IP address in the following field.

When Network Address Translation is set to Full Feature, but there is no NAT rule configured, the warning message “Warning! No NAT rule configured in system” appears in the status bar.

WAN Screens

6-9