3M SE, DL user manual Curves screen Mode, Type

89

Captured curves

Setting up captured curves

•Evaluation Mode: evaluates the noise levels against specific criterion. This is primarily used when you are capturing one to four different curves. With this option, you assign a Capture name (Cap-1,Cap-2,Cap-3,Cap-4) in the setup menu and then run a captured curve study. To assign a new captured curve name, you return to the Options menu, select a name and then return back to view session mode and run your study.

NOTE: Whether you choose Survey or Evaluation mode, the captured curved results will report the same data. The survey mode is recommended for Captured Curves since it is slightly easier to use in the field.

8.Depending on your selection in step 4, refer to the following:

•If Survey Mode was selected, please see step 6.

• If Evaluation mode was selected, press Up/Down		to highlight
Criterion. Repeatedly press Enter	to select Cap-1, Cap-2, Cap-3,
Cap-4.

9.Press On/Off/Esc twice to return to the start screen.

Curves screen

Mode

Press Enter repeatedly to toggle between Survey and Evaluation modes.

Type

“Captured (CAP)” automatically appears when you select Survey as the type.

Figure 6-9: Captured Curves and Survey mode

Models SE and DL