53

Communications

Viewing real-time measurements remotely

USB communications

1.If a session is running, stop it.

2.In the Start screen, press to select Setup, then press . The Setup screen appears.

3.In the Setup screen, press the arrow keys to select Comm Set, then press and the Comm-Set screen appears.

4. USB should be Highlighted. Press

to toggle between “QSP/Serial” and

“Mass Storage”.

 

5.If the RS-232 channel is not set to “Off/Lo-Pwr”, press the left arrow to

highlight RS-232 and repeatedly press until Off/Lo-Pwr is displayed.

6.Press to exit the screen.

7.Connect the small end of the USB cable to the USB port (“Hardware interfaces” on page 6).

8.Connect the large end of the USB cable to a standard-sized USB connector on the computer.

Viewing real-time measurements remotely

On the SoundPro, the “Log to Port” feature, provides the functionality to stream logged data out the serial port at the log rate to an external device (such as a pc). With this feature, you are able to view logged measurements for broadband as well as filter band average measurements (depending on the model you ordered). It will not report Lmax, Lmin, or Lpk for each filter band.

Turning on log to port

1.In the Comm Set screen (selectable via the Set-up screen), select RS-232 field (by pressing the down arrow).

2. Press

repeatedly to turn on LOG PRN.

LOG to Port

Press Enter key repeatedly to activate

Figure 4-16: Log to Port

Models SE and DL

Page 66
Image 66
3M SE, DL user manual Viewing real-time measurements remotely,  USB communications,  Turning on log to port, LOG to Port