93 Criterion curve families

Setting up criterion curves

3.Press On/Off/Esc to return to the start screen.

4.Select Setup (use up/down arrows to highlight) and press Enter .

5.Select Options menu (use up/down arrows to highlight) and press Enter .

6.Select Curves menu (use up/down arrows to highlight) and press Enter .

Curves screen

Evaluation mode

Figure 6-13: Curves setup screen example

7.For the Mode, press Enter repeatedly to select either Survey or Evaluation setting. (Please see explanation below).

Survey Mode: dynamically evaluates the noise and reports the appropriate noise curve. Typically used if you wish to take multiple curve samples to evaluate and re-evaluate noise in a room/zone.

Evaluation Mode: evaluates the noise levels against specific criterion.

NOTE: Whether you choose Survey or Evaluation mode, the criterion curved results will report the same data.

8.Select a type by pressing Up/Down to move to the Type field.

9.Repeatedly press Enter to toggle between the five-criterion curve options.

NOTE: Depending on the Criterion curve you select, you may or may not have the option to set the Criterion field. If the Criterion field appears once you select the type, adjust this field by using the Up/Down arrows to move to the field and press enter repeatedly to change the criterion.

10.Press On/Off/Esc twice to return to the start screen.

To run your Curve study, please see section, Running and viewing a curve study.

Models SE and DL

Page 106
Image 106
3M SE, DL user manual Curves setup screen example