3M DL, SE user manual Level-triggered auto-on setting,  Viewing or changing level-triggered mode

44

Setting up auto-run

Level-triggered auto-on setting

Level-triggered auto-on setting

The level-triggered screen contains meter 1 parameters which include a Filter mode, Frequency level, “Level On” and “Level Off” modes, and a specification for either run/stop or run/pause modes.

Viewing or changing level-triggered mode

1.From the start screen, press Up/Down to highlight Setup and press Enter .

2.Select Auto-Runby using Up/Down to highlight and press Enter to select.

3.In the Auto-Run screen, repeatedly press Enter until Level- Triggered appears.

4.Press the Down arrow to select View/Set Parameters and press Enter . The Level-Triggered Auto-Run screen will appear.

•See Table 4-1 below for explanation of settings.

						Mode: to enable a
						filter mode, select
			\setup\LVL-TRG-RUN			Level On/Off or
	A					Windowed
			MODE	LEVEL ON/OFF
						Action: Run/Pause
	B		ACTION	RUN/PSE
						or Run/Stop
			TRIGGER	RUN	PAUSE
	C					Source/Level:
			SOURCE	METER 1	METER 2	Select one of the 5
	D		LEVEL	90.0	OFF	features and then
						set an appropriate
						Level.
			Figure 4-7: Level-Triggered screen
Level-		Explanation of Settings
Triggered
A. Mode		The mode, or Filtered Mode, can be set to Level On/Off and Windowed
		settings.
		•	In Level On/Off mode, the unit starts a run when the source level
			exceeds the specified criteria and stops/pauses when level falls below the
			off criteria. The on criteria is met and either pause or stop a run when the
			off criteria is met.
		•	In Windowed mode, the unit starts a run when the selected criteria falls
			outside the defined window. This is intended primarily for curves but can
			also be used with broadband or individual filter measurements.
						Models SE and DL