27

Basic setups

Meter 1/Meter 2 Parameters (i.e. response time, weighting)

Meter 1/Meter 2 Parameters (i.e. response time, weighting)

Setting up Meter 1 and Meter 2 parameter settings are changed through the softkeys and the Measure Set screen of the SoundPro.

Setting up Meter 1 and/or Meter 2 parameters

1.Ensure you are at the start screen.

If turned on, press On/Off/Esc repeatedly until you return to the start screen (see Figure 3-3).

2.Press Up/Down to highlight Setup and then press Enter .

3.Select Meter Set by pressing Up/Down to highlight and then press Enter .

4.To set the response time for Meter 1, press the second softkey repeatedly until the either Fast (F), Slow (S), or Impulse (I) is selected.

An underline denotes which feature is selected.

5.To set the weighting for Meter 1, press the third softkey repeatedly until either A, C, Z, of F is underlined (or selected).

To set Meter 2 response time and weighting, press 4th softkey until Meter 2 is selected. Then repeat steps 4 & 5.

6. To change the Meter parameters, press Up/Down

to select one of

the Meter Set fields.

 

7.To change any of the values, press Enter to move to the data fields.

Continue to press Enter until the specified setting is selected. Press the Left arrow to return to the Meter Set fields.

Meter Set fields Press up/down arrows to move between the parameters

Parameters

Press Enter repeatedly to toggle through the selections

2ND softkey– Response time

3RD softkey– Weighting

4th softkey– Meter 1/Meter 2

Figure 3-4: Meter 1 and Meter 2 parameters

Models SE and DL

Page 40
Image 40
3M SE, DL Meter 1/Meter 2 Parameters i.e. response time, weighting,  Setting up Meter 1 and/or Meter 2 parameters