3M DL, SE user manual Adding code for secure/lock screen, Press Enter to Enable

48

Locking setup or run mode

Setting secure run or secure setup (locking)

3.(Skip this step if securing setup and see step 4.) To set Secure Run Mode, press Enter and “0000” will appear.

NOTE: if you want to set the code as “0000,” press Enter repeatedly until “enabled” appears. This will be the unlock code.

•Selected value is shaded

•Enter code by pressing up/down arrows to change value

•Press enter to move to each field

Figure 4-10: Adding code for secure/lock screen

•To select a numeric code, press Up/Down arrows to select a number, press Enter to toggle between the fields.

•Press Enter to Enable.

•Press On/Off/Esc key to return to the Start screen. When you are ready to run a session, press the Run/Pause key and the Secure Run Mode prompt will appear. (See “Disabling secure run or secure setup” below for details on stopping the run.)

To unlock/unsecure Press lock softkey and then enter in code.

Figure 4-11: Secure/lock run prompt

Models SE and DL