Installing the Paper Roll
Installing the Paper Roll
Your cash register has a thermal printer that prints receipts for the customer or a journal tape. You can use 2¼ inch (57.5 mm) wide standard thermal register paper.
To install the paper roll
1Insert the PRG key and turn it to either REG1 or REG2.
•If you need a customer receipt, turn the Mode key to the REG1 position.
•If you do not need a customer receipt, turn the mode key to the REG2 position.
2Unlock and open the Journal Compartment Cover. Grip the left side of the cover and gently pull upward. Remove the Journal Compartment Cover and set aside.
3Remove the Journal
Takeup spindle. Place the paper roll in the little round area at the bottom of the compartment. Make sure the paper feeds out from the bottom of the roll, towards the front of the cash register.
4 Grab the small handle on the right | Handle |
of the print roller. Push the little |
|
handle towards the back of the cash |
|
register and raise the roller bar up. |
|
5Lay the end of the paper across the printer as shown. Move the print roller down onto the paper and snap into place. Make sure both sides are snapped down.
•Press the Feed key until the paper catches and moves through the printer.
6Do one of the following:
Alpha 583cx User’s Guide | 5 |
abcoffice www.abcoffice.com
