Agilent Technologies 87075C Connect the Test Set to the Analyzer, Installing the System in a Rack

Introduction and Installation

Installation

Step 3. Connect the Test Set to the Analyzer

For using your system on a bench, configure and connect the two instruments as shown in Figure 1-3: Connect the Parallel In connector of the test set to the analyzer Parallel connector. Use the parallel cable that was shipped with the multiport test set.

If you will be installing your system in a rack, read “Installing the System in a

Rack,” next in this section, before connecting the test set to the analyzer.

Figure 1-3 System Configuration

Installing the System in a Rack

The rack mount kit for the test set is Option 1CM when ordered with the test set, or part number 5063-9214 when ordered separately.

12 Chapter 1