Agilent Technologies 87075C manual Performing Measurements

Making Measurements

Measurement Procedures

		Performing Measurements
		The procedure to execute measurement is described below. This section describes
		how to trigger actual measurement. For more information, see the E5061A/62A
		User’s Guide.
	Step 1.	Setting the trigger source
		Select a trigger source. Because the trigger source is common to all the channels,
		you need not to set it channel by channel.
		[Trigger] - Trigger Source - Corresponding softkey
	Step 2.	Setting the trigger mode
		Select a trigger mode. You must set it separately for each channel.
		[Trigger] - Corresponding softkey
	Step 3.	Generating a trigger
		Generate a trigger from the trigger source specified in setting the trigger source.
NOTE		If the internal trigger is specified, triggers are generated continuously immediately
		after the setting.
	Step 4.	Adjusting the settings
		Adjust each setting made in “Setting the measurement conditions” according to your
		measurement needs.

Chapter 2 27