Agilent Technologies 87075C manual Activate the Test Set, Introduction and Installation, Chapter

Introduction and Installation

Installation

	Step 5. Activate the Test Set
	1. Connect the semi-rigid cables that were shipped with your test set as shown in
	Figure 1-6. Check Table 1-1to be sure that you are using the correct cables with
	your system configuration (the cables you use will be different depending on
	whether you are using a bench system configuration—as shown in Figure
	1-6—or a rack configuration).
Figure 1-6	Connect the Front Panel RF Cables

NOTE	Steps 2 and 3 must be performed before you can use your network analyzer to
	control the multiport test set.
	2.	Turn on the test set.
	3.	Turn on the analyzer and Press [System] -87075 Setup - 87075 Control to
		activate the test set control.

Chapter 1 17