User’s Guide
B.2 Parallel Interface Enable/Disable
1.Set the power switch to On.
2.Press the On/Off Line key.
3.Open the Keypad Door. The first menu will appear on the display.
4.Press the Next Menu key until you have accessed Menu 6. The display will appear as shown:
M6 PARALLEL CONTROL
5.Press the Feature ▲ key to select the Parallel feature.
6.Press the Value ▼ key to select enable/disable.
7.Press the Enter key to accept your selection.
There are three additional features which allow you to configure the parallel interface
to suit your needs: Handshake, [BUSY, ACK], [ACK, BUSY, BEFORE, AFTER]. and [8th Bit ENABLE, DISABLE]. All three features are contained in Menu 6: Parallel Control. Each feature is explained in detail in Chapter 4. After you finish your parallel interface configuration, continue with Step 8.
8.Close the Keypad Door to exit Setup Mode. The alternating message will be displayed.
Press ‘Profile’
To Save Settings
9.Press the Profile key to save the setting in
10.Press the On/Off Line key to place the printer back on line.
