AMT Datasouth 3300 manual Top of Form Adjustment Adjusting First Printline Location

User’s Guide

3.4Top of Form Adjustment

(Adjusting First Printline Location)

NOTE

Perform this adjustment immediately after loading paper to determine where the first line will print. Making this adjustment while printing on the page allows fine alignment without resetting line count.

When paper is loaded into the printer, the printer automatically positions the paper to print on the first line of the form. If you need to change the location of the first print line, use the Adjust Form key and proceed as follows:

1.To place the printer in Top-of-Form Adjust Mode, open the Keypad Door and press the Adjust Form key. The form will advance until the bottom of the first print line is positioned just above the tear off bar for viewing (Figure 3-9). (For units equipped with cut sheet option, open the Top Access Cover and use the metal tear edge just above the top rollers.)

2.Use the Value ▲ and Value ▼ keys to move the paper up or down to the position desired for first line of type. The line directly above the tear bar will be the first print line (Figure 3-9).

3.Press the Adjust Form key or close Keypad Door. The printer will reverse feed the form back to print position.

4.This adjustment affects the Load feature and is automatically saved in memory for the current profile and will apply the next time forms are loaded.

Forms Handling 3-13