User’s Guide
Symptom
Corrective Action
Printer Will Not Switch Paths | Change the Path Value to “Either” under M2: Forms |
| Control. (See Section 3.8 – 3.13). |
| Verify the Config feature in M10 matches the |
| configuration of the printer. |
|
|
First Print Line Location is | Readjust the first print line using the instructions in |
Wrong | Section 3.4. |
|
|
Print Contrast on Last Sheet | Verify the forms thickness setting is correct for the form |
is Too Light | being used. |
|
|
| Enable the High Impact feature under M4: Printer Control |
| (See Section 4.6 – 4.7) |
|
|
| Select an NLQ font listed in Section 3.4. |
|
|
Printer is Too Noisy | Enable Quiet Mode feature under the M8: Form |
| Thickness Control. (See Section 4.6 – 4.7). |
|
|
