User’s Guide
B.4 Serial Interface Selection
1.Set the power switch to On.
2.Press the On/Off Line key.
3.Open the Keypad Door. The first menu will appear on the display.
4.Press the Next Menu key until you have accessed Menu 5. The display will appear as shown:
M5 SERIAL CNTRL
5.Press the Feature ▼ ▲ keys to select the Serial feature.
6.Press the Value ▼ key to select
7.Press the Enter key to accept your selection.
There are five additional features which allow you to configure the serial interface to suit your needs: Parity, Data Bits, DTR, Handshake and Modem Control. All five features are contained in Menu 5: Serial Control. Each feature is explained in detail in Chapter 4. After you finish your serial interface configuration, continue with Step 8.
8.Close the Keypad Door to exit Setup Mode. The message will alternate on the display as shown:
Press ‘Profile’
To Save Settings
9.Press the Profile key to save profile.
10.Press the On/Off Line key to place the printer back on line.
