User’s Guide
1.2Quick Start Up Procedure
The following is an abbreviated installation and start up procedure provided for users who are already familiar with printer products. If you are not experienced with printers, follow all the instructions in Chapter 1 for setting up the printer.
1.Place the printer on a suitable stand or countertop.
2.Install ribbon cartridge and power cord.
WARNING
CONNECT 115V UNITS TO 115V
OUTLETS ONLY! PRINTER DAMAGE
WILL RESULT!
3.Turn printer on
4.Position left tractor with ‘Alignment’ mark on printer. Position front paper guides and rear paper supports equally across the width of the form. Load 8 ½” paper into tractors. (For cut sheet forms, set the left cut sheet guide to “0” and insert 8 ½” paper).
5.Press the Load Key(unnecessary for cut sheet path).
6.Open Keypad Door to enter Setup Mode.
7.Use the Quick Access Key, the Value ▲▼ keys, and the Enter Keyto set margins.
8.Close the Keypad Door.
9.Press the Profile Key to save settings.
