AMX MVP-8400i manual System Settings Page Elements, Master Connection

Setup Pages

System Settings Page

The System Settings page (FIG. 53) displays sets the NetLinx Master’s communication settings.

FIG. 53 System Settings page

The elements of this page include:

System Settings Page Elements

Back:	Saves all changes and returns to the previous page.
WiFi/Wired icon:	The icon to the left of the Connection Status Icon displays whether the current
	connection to the Master is Wireless (image of a radio antenna) or Wired
	(image of three networked computers).
Connection Status icon:	The icon in the upper-right corner of each Setup page shows online/offline state
	of the panel to the master.
	•	Bright red - disconnected
	•	Bright green - connected. Blinks when a blink message is received to dark
		green every 5 seconds for half a second then go back to bright green.
	•	Bright yellow - panel missed a blink message from the master. It will
		remain yellow for 3 missed blink messages and then turn red. It will return
		to green when a blink message is received.
	Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
	Master.
Master Connection:	Sets the NetLinx Master communication values:
Type
	Sets the NetLinx Master to communicate with the panel via either USB or
	Ethernet. This is based on the cable connection from the rear.
	Note: ICSNet is not a supported option on this panel.
	•	Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45
		connector) used to network computers together and is used in most LAN
		(local area networks). This description is also used to refer to both wired
		and wireless communication.
	•	USB option cannot be used on Modero panels that are not equipped with
		a rear USB port.

MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom 55