3.Grasp the bottom rim of the rear housing just above the MVP interface connector, and carefully pull the bottom rim away from the IR Emitter and up, to expose the internal components.
4.Remove the trim from the top rim of the circuit board (FIG. 5).
Removing the Installed Card
1.Discharge any static electricity from your body by touching a grounded metal object and then locate the card slot on the main circuit board (FIG. 6).
2.Place the circuit board on a flat level surface so that the IR Emitters are pointing away from you (FIG. 6).
3.Insert the tip of a grounded
4.Slip your finger into the gap between the card and the circuit board and firmly grab the card by its sides, then carefully pull it up and out of the slot. An angular removal of the card is required because one of the housing’s latch attachments blocks the slot opening.
use care when pulling up on the card.
Installing the Compact Flash Upgrade Card
1.Discharge any static electricity from your body by touching a grounded metal object and then locate the memory card slot on the main board (A in FIG. 6).
Card removal grooves |
| Internal circuit board | ||
| ||||
| (top view - detail) | |||
|
|
|
| |
|
|
|
|
|
IR Emitters 
Compact Flash 
card
A | B | Wireless Interface |
|
| |
|
| card |
FIG. 6 Location and orientation of the Compact Flash cards (both MVP panels)
2.Place the circuit board on a flat level surface so that the IR Emitters are pointing away from you (FIG. 6).
3.Insert the tip of a grounded
4.Slip your finger into the opening (between the connector pins and the card resulting from step 3) and push the card out.
5.Finish the process by firmly gripping the exposed sides of the card and pulling it out (FIG. 7). USE CARE WHEN
HANDLING THE CARD.
8 |
