Configuring Communications

FIG. 33 Web Control VNC installation and Password entry screens

The G4 Web Control application is sent by the panel to the computer that is used for communication. Once the application is installed, this popup will no longer appear. This popup will only appear if you are connecting to the target panel using a different computer.

8.In some cases, you might get a Connection Details dialog (FIG. 34) requesting a VNC Server IP Address. This is the IP Address not the IP of the Master but of the target touch panel. Depending on which method of communication you are using, it can be found in either the:

Wired Ethernet - System Settings > IP Settings section within the IP Address field.

Wireless - Wireless Settings > IP Settings section within the IP Address field.

If you do not get this field continue to step 9.

IP Address of touch panel

- obtained from IP Settings section of the Wireless Settings page (MVP)

FIG. 34 Connection Details dialog

9.If a WebControl password was setup on the G4 WebControl page, a G4 Authentication Session password dialog box appears on the screen within the secondary browser window.

10.Enter the Web Control session password into the Session Password field (FIG. 34). This password was previously entered into the Web Control Password field within the G4 Web Control page on the panel.

11.Click OK to send the password to the panel and begin the session. A confirmation message appears stating "Please wait, Initial screen loading.".

The secondary window then becomes populated with the same G4 page being displayed on the target G4 panel. A small circle appears within the on-screen G4 panel page and corresponds to the location of the mouse cursor. A left-mouse click on the computer-displayed panel page equates to an actual touch on the target G4 panel page.

32

MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom

Page 46
Image 46
AMX MVP-8400i manual Web Control VNC installation and Password entry screens