AMX MVP-8400i manual @Ppm, @Ppn, @Ppt, @Ppx, @Pse

Programming

Page Commands (Cont.)

@PPM	A Modal popup page, when active, only allows you to use the buttons and features on that
Set the modality	popup page. All other buttons on the panel page are inactivated.
	Syntax:
of a specific
popup page to	"'@PPM-<popup page name>;<mode>'"
Modal or	Variable:
NonModal.
	popup page name = 1 - 50 ASCII characters. Name of the popup page.
	mode = NONMODAL converts a previously Modal popup page to a NonModal.
	MODAL converts a previously NonModal popup page to Modal.
	modal = 1 and non-modal = 0
	Example:
	SEND_COMMAND Panel,"'@PPM-Popup1;Modal'"
	Sets the popup page ’Popup1’ to Modal.
	SEND_COMMAND Panel,"'@PPM-Popup1;1'"
	Sets the popup page ’Popup1’ to Modal.
@PPN	If the page name is empty, the current page is used (see example 2). If the popup page is
Activate a	already on, do not re-draw it. This command works in the same way as the ’Show Popup’
	command in TPDesign4.
specific popup
	Syntax:
page to launch on
either a specified	"'@PPN-<popup page name>;<page name>'"
page or the	Variable:
current page.
	popup page name = 1 - 50 ASCII characters. Name of the popup page.
	page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
	Example:
	SEND_COMMAND Panel,"'@PPN-Popup1;Main'"
	Activates ’Popup1’ on the ’Main’ page.
	Example 2:
	SEND_COMMAND Panel,"'@PPN-Popup1'"
	Activates the popup page ’Popup1’ on the current page.
@PPT	If timeout is empty, popup page will clear the timeout.
Set a specific	Syntax:
popup page to	"'@PPT-<popup page name>;<timeout>'"
timeout within a	Variable:
specified time.
	popup page name = 1 - 50 ASCII characters. Name of the popup page.
	timeout = Timeout duration in 1/10ths of a second.
	Example:
	SEND_COMMAND Panel,"'@PPT-Popup1;30'"
	Sets the popup page ’Popup1’ to timeout within 3 seconds.
@PPX	This command works in the same way as the 'Clear All' command in TPDesign 4.
Close all	Syntax:
popups on all	"'@PPX'"
pages.	Example:
	SEND_COMMAND Panel,"'@PPX'"
	Close all popups on all pages.
@PSE	Syntax:
Set the show	"'@PSE-<popup page name>;<show effect name>'"
effect for the	Variable:
specified popup	popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
page to the
	On.
named show
	show effect name = Refers to the popup effect name being used.
effect.
	Example:
	SEND_COMMAND Panel,"'@PSE-Popup1;Slide from Left'"
	Sets the Popup1 show effect name to ’Slide from Left’.

98 MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom