AMX MVP-8400i manual RAF, RMF Embedded Codes, Rmf, Rsr, Parameter Embedded Code Description

Programming

Dynamic Image Commands (Cont.)

^RMF	Modifies any and all resource parameters by sending embedded codes and data.
Modify an	Since the embedded codes are preceded by a '%' character, any '%' character contained
existing resource.	in the URL must be escaped with a second '%' character (see example).
	The file name field (indicated by a %F embedded code) may contain special escape
	sequences as shown in the ^RAF, ^RMF - Embedded Codes section on page 148.
	Syntax:
	"'^RMF-<resource name>,<data>'"
	Variables:
	•resource name = 1 - 50 ASCII characters
	•data = Refers to the embedded codes, see the ^RAF, ^RMF - Embedded
	Codes section on page 148.
	Example:
	SEND_COMMAND Panel,"'^RMF-Sports_Image,%ALab%%5FTest/
	Images%Ftest.jpg'"
	Changes the resource ’Sports_Image’ file name to ’test.jpg’ and the path to ’Lab_Test/
	Images’.
	Note that the %%5F in the file path is actually encoded as %5F.
^RSR	Syntax:
Change the	"'^RSR-<resource name>,<refresh rate>'"
refresh rate for a	Variable:
given resource.	resource name = 1 - 50 ASCII characters.
	refresh rate = Measured in seconds.
	Example:
	SEND_COMMAND Panel,"'^RSR-Sports_Image,5'"
	Sets the refresh rate to 5 seconds for the given resource (’Sports_Image’).

^RAF, ^RMF - Embedded Codes

The ^RAF and ^RMF commands add and modify any and all resource parameters by sending embedded codes and data:

"'^RAF-<resource name>,<data>'"

"'^RMF-<resource name>,<data>'"

The <data> variable uses the embedded codes described in the following table:

	^RAF, ^RMF - Embedded Codes
	Parameter	Embedded Code	Description
	protocol	’%P <0-1>’	Set protocol. HTTP (0) or FTP (1).
	user	’%U <user>’	Set Username for authentication.
	password	’%S <password>’	Set Password for authentication.
	host	’%H <host>’	Set Host Name (fully qualified DNS or IP Address).
	file	’%F <file>’	Full path to the location of the file or program that will return
			the resource. The path must be a valid HTTP URL minus the
			protocol and host.
			The only exception to this is the inclusion of special escape
			sequences and in the case of FTP protocol, regular
			expressions.
	path	’%A <path>’	Set Directory path. The path must be a valid HTTP URL minus
			the protocol, host and filename.
			The only exception to this is the inclusion of special escape
			sequences and in the case of FTP protocol, regular
			expressions.
	refresh	’%R <refresh 1-65535>’	The number of seconds between refreshes in which the
			resource is downloaded again. Refreshing a resource causes
			the button displaying that resource to refresh also.
			The default value is 0 (only download the resource once).
148
			MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom