Anaheim DPJ72LC4, DPJ72LC3, DPJ72LC2 manual Thank You, Product Support, System Requirements

Section 1 Getting Started 1

Section 1. Getting Started

Thank You

Thank you for purchasing Anaheim Automation’s LC controls, the affordable, powerful CNC control system for Windows®. No other CNC system is easier to set up and use than the LC. We’re sure you’ll enjoy easy to use menus and real time graphics as you quickly and accurately cut parts on your machine tool.

We are committed to the excellence of the LC controls. Feel free to call us with any comments or questions.

Product Support

We are committed to full support of the LC controller product line. There are three support options:

Phone: (714) 992-6990	8:00 AM-5:00 PM, Pac. Time, M-F
Fax: (714) 992-0471	24 hours a day, 7 days a week.
E-mail: support@anaheimautomation.com	24 hours a day, 7 days a week.
Web Site: www.anaheimautomation.com	24 hours a day, 7 days a week.

System Requirements

∙IBM PC or 100% compatible with a 66MHz or faster 80486DX, Pentium, or higher CPU.

∙At least 8MB of RAM.

∙Hard drive with at least 20MB of space available.

∙3.5 inch, 1.44-MB floppy disk drives.

∙VGA, SVGA or compatible video monitor.

∙A Microsoft-compatible mouse. Note that for best performance, the mouse should connect directly to the bus (the standard mouse plug on most systems), or through a mouse bus port rather than through a serial port.

∙One available RS-232 serial port. If the port has a 25-pin connector, a 9-pin male to 25-pin female adapter will be required.

∙Microsoft Windows 95, 98 or NT or Microsoft or PC DOS version 3.1 or later running Microsoft Windows version 3.1 or 3.11.