Removal

Note: Observe the Bluetooth and microphone cable routing before removing the pressure wall. The Bluetooth cable routes over the pressure wall and the microphone cable routes under (illustration shows a non-SSD config). On SSD configs the Bluetooth cable routes over the top of the SSD drive.

1Remove 1 T8 screw on pressure wall.

922-9241

2(Illustration shows SSD drive config) Use a black stick to pry pressure wall off rear housing. Dotted line represents location of adhesive.

Exert some force to release pressure wall.

3If replacing pressure wall and the SSD drive is installed, remove SSD drive from pressure wall and transfer SSD to new pressure wall.

2010-09-09

iMac (27-inch, Mid 2010) Take Apart — Optical/MXM Pressure Wall  226

Page 226
Image 226
Apple MD094LL/A manual Remove 1 T8 screw on pressure wall