Baldor GLC30 Action, Description, Display, Comments, Controller is in “OFF” position from the

Display Modes The controller is in the display mode at all times except when in the programming mode. The display screens and menus may be selected by pressing the Enter or Exit keys to access Operating Status Display, Fault Display, Timer Countdown, Generator AC Metering or Programming Menus. The LCD display shows the status of the generator output:

Operating Status The controller will power-up into an Emergency Stop failure mode, preventing possible engine operation. The controller must be manually reset before normal operation can be established. To reset the Emergency Stop condition, press the “OFF” push-button first, then press both “INCREMENT” and “ENTER” push-buttons simultaneously. The controller will then reset, if a remote emergency stop condition is not activated. The Utility Ready to Load programmable output will energize if the remote start contact is open. The Main LCD Display will be shown.

Action	Description		Display		Comments
Apply Power and	Main LCD Display.
		Vavg	Aavg	Freq
Reset faults.		000	000	000
Press Enter key	Show Operating Status screens				Controller is in “Auto” position and there
			UNIT READY
					are no active faults.
Press ↑ or ↓ key	Scroll to next.				Controller is in “OFF” position from the
		SWITCH IN OFF
					front panel keypad push-button.
Press ↑ or ↓ key	Scroll to next.				Engine is running and all conditions are
		UNIT RUNNING
					normal.
Press ↑ or ↓ key	Scroll to next.				A shutdown fault is active. The specific
		UNIT SHUTDOWN
					fault will be automatically displayed.
Press ↑ or ↓ key	Scroll to next.				One or more faults are active. The
		UNIT ALARM
					display will automatically scroll through
					all active faults at a two second rate.

Fault Display The fault display menu is automatically displayed when an alarm or shutdown fault is activated. The specific alarm or shutdown fault label will be displayed and if multiple alarm conditions are present, the display will automatically scroll through all active faults.

MN2408 Operation 4‐21