Brother MFC 4300 Real Time Transmission, Checking the Jobs Status, Real Time TX, Realtime TXON?

Your MFC normally operates in Dual Access mode. However, you can override Dual Access by using Real Time Transmission.

3Enter the fax number.

4Press Start. The MFC starts scanning the original and the screen displays the job number (#XX) of the fax, and how much memory is available. Then the MFC starts dialing. You can immediately repeat Steps 1 through 4 for the next fax.

Note

	Real Time Transmission
	When you are sending a fax, the MFC will scan originals into memory before
	sending. Then, as soon as the phone line is free, the MFC will start dialing and
	sending the fax. If memory becomes full, the MFC will send the document in
	real time, even if REAL TIME TX is set to OFF.
	Sometimes you may want to send an important document immediately, without
	waiting for memory transmission. You can set REAL TIME TX to ON.
1	Place the original face down in the ADF.
2	Press Function, 1, 3, 9.	9.REAL TIME TX
3
	To change the default setting, press or	REALTIME TX:ON?

to select ON (or OFF), and then press Set. Go to Step 5—OR—For the next fax

transmission only, press or to select NEXT FAX ONLY, and then press Set.

4For the next fax only, press or to select ON (or OFF), and then press Set.

5Press 1 if you want to select additional settings. The LCD returns to the SETUP SEND menu—OR—Press 2 if you are finished choosing settings, and then go to Step 6.

6Enter fax number, and then press Start.

Checking the Jobs Status

Check which jobs are still waiting in memory to be sent. (If no jobs are waiting, the LCD shows NO JOB WAITING.) (See Canceling Jobs in Memory, page 6-4.)

1If the machine is idle, Press Function, 1, 4.

—OR—

If the machine is busy, go to step 2.

2If you have multiple jobs waiting, use or to scroll through the list.

3Press Stop to exit.

6 - 3 S E T U P S E N D