Brother MFC 4300 owner manual Setting the Speaker Volume, Setting the Ring Volume, Memory Storage

VOL AMPLIFY:OFF? SELECT <- -> & SET

PERMANENT?

SELECT <- -> & SET

Setting Volume Amplify

Please carefully read “Setting the Handset Volume” before you do the following steps:

1Press Function, 1, 1, 6.

2 Press or to select

VOL AMPLIFY:OFF? if none of the users are hearing-impaired, and then go to Step 4.

—OR—

If some or all of the users are hearing- impaired, select VOL AMPLIFY:ON?.

3 If all the users are hearing-impaired, press

or to select PERMANENT?, and then press Set.

—OR—

If only some of the users are hearing-impaired, select TEMPORARY?, and then press Set.

4Press Stop to exit.

Setting the Speaker Volume

You can adjust the speaker volume of your MFC. First press Hook, then press or to select a speaker volume level.

When you press or to adjust the volume level, the LCD shows the setting you are choosing. Each key press changes the volume to the next level. The new setting will remain until you change it again.

Setting the Ring Volume

You can adjust the ring volume when your MFC is idle. You can turn the ring off or you can select a ring volume level.

As you press or to adjust the volume level, the MFC rings so you can hear the volume for the level shown on the LCD. Each key press changes the volume to the next setting. The new setting will remain until you change it again.

Memory Storage

In the event of a power failure, all settings in the INITIAL SETUP, SETUP RECEIVE, SET AUTO DIAL, and REMOTE FAX OPT functions plus the COVERPG SETUP and COVERPG MSG (from SETUP SEND) functions are stored permanently. You may have to reset the date and time.

4 - 5 I N I T I A L S E T U P