Brother MFC 4300 owner manual Setting Beeper Volume, Setting the Handset Volume

Setting Beeper Volume

You can set the beeper to LOW, HIGH or OFF. The default setting is LOW. When the beeper is set to LOW or HIGH, the MFC beeps every time you press a key or make an error, and at the end of fax sending or receiving.

1Press Function, 1, 1, 3.

2Press or to select your setting, and then press Set.

3Press Stop to exit.

Setting the Handset Volume

Before you begin to use the MFC, you must decide if you need to set the handset volume to AMPLIFY:ON for a user who is hearing-impaired. The AMPLIFY volume level complies with FCC standards.

VOLUME AMPLIFY: OFF

This default setting is appropriate if none of the users are hearing-impaired. During a conversation, users can press or on the control panel to adjust the volume. When the handset is replaced, the handset volume remains until you change it again.

VOLUME AMPLIFY: ON–TEMPORARY

This setting is appropriate if some of the users are hearing-impaired. During a conversation, users can press or on the control panel to adjust the volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset volume will return to the default setting of LOW.

VOLUME AMPLIFY:ON–PERMANENT

Choose VOL AMPLIFY:ON–PERMANENT if all of the users are hearing- impaired. During a conversation, users can press or on the control panel to adjust the volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset volume returns to the default setting of AMPLIFY. When you press or on the control panel to adjust the volume, the display shows the setting you are choosing. Each key press changes the volume to the next setting.

WARNING

It is important that you do NOT choose PERMANENT unless all users are hearing-impaired. Otherwise, the default setting of AMPLIFY may damage the hearing of some users.

I N I T I A L S E T U P 4 - 4