Konica Minolta 750 manual Punching Holes in Copies Punch Settings Detail, Paper Weight Paper Size

Basic Copy Operations 3

Punching Holes in Copies (Punch Settings)

!

Detail

In order for holes to be punched in the copies, all of the following condi- tions must be met.

The paper width must be between 5-13/16 in. and 12-3/8 in.

The paper length must be between 8-1/4 in. and 16-9/16 in.

If a Punch setting is to be selected, select the orientation in which the document is positioned. If an Original Direction setting is not selected, holes may not be punched in the copies as desired.

For details on specifying the document orientation, refer to “Selecting the Original Orientation (Original Direction Settings)” on page 3-20.

If a Punch setting is selected, specify the position of the binding margin and the loading orientation for the original, otherwise the holes will not be punched as desired.

For details on specifying the loading orientation for the original, refer to “Selecting the Original Orientation (Original Direction Settings)” on page 3-20. For details on specifying the position of the binding margin for the original, refer to “Selecting the Position of the Binding Margin (Margin Settings)” on page 3-22.

Basic Copy Operations Chapter 3

Note

The number of punched holes differs depending on the country (region) where the unit is installed. For details, consult your technical representa- tive.

The number of holes that can be punched differs depending on the type of punch kit installed.If different hole punch settings are available, select the setting for the desired use.

The procedure for selecting two punched holes is described below.

When Finisher FS-504/FS-602 and Punch Kit PK-505 are installed is installed

Paper Weight	Paper Size
13-1/4lb to 34lb	11 × 17w, 8-1/2 × 14w, 8-1/2 × 11w/v, 5-1/2 × 8-1/2w/v,
	Exectivew/v, Foolscap w

bizhub 750/600 3-63